Frozen River

Cracked Ice

Close up

Models on ice

I finally found an affordable solution for making the frozen river for my ice board.  Ceiling panels for florescent lights to simulate the ice. This is a translucent cracked ice type and runs about 10 bucks for a 2x4 foot section.  Two of them will be enough to do the large river on my table.  Certainly better than the estimated $100 bucks worth of resin I thought I was going to need.  I had thought about trying it, but saw it in action here and new it would be perfect.

The one problem I ran into is that the panels are actually 23.5 inches vs 47.5 inches.  So for one of the panels I needed to use multiple pieces.  Rather than have a straight seam, I cracked and broke it into pieces and then used Woodland Scenics Realistic Water to make it look like the water was flowing up through the crack.  The water seeped under the plastic to give a really nice looking effect.  I'm really happy, I just need to do some snow banks along the edges to cover up the rough cutting.